Hardware Features
4. GRWIC slots 0, 1, 2, and 3 (0, far right).
5. For T1/E1 interfaces, shielded cables are required to meet EN55022, Cispr 22, and EN300-386 compliance.
Built-in Interface Ports
Table 1-1
Table 1-1
Router
Model
Cisco 2010
CGR
Gigabit Ethernet Ports
There are two different types of GE ports available on Cisco 2010 CGR.
•
•
GE Ports
The GE RJ-45 copper interface ports support 100BASE-TX and 1000BASE-T.
SFP Ports
The small form factor pluggable (SFP) ports on the Cisco 2010 CGR support the following rugged SFP
SKUs:
•
•
•
•
•
The SFP port shares the same physical port as an RJ-45 GE port.
The SFP port can be configured for the following behaviors:
•
•
USB Console Port
The Mini-USB type B port has been enabled to perform management tasks on the router. To use this port,
you must install a Windows USB device driver before establishing physical connectivity between a
personal computer and the router. See the
section on page 3-13
Cisco Connected Grid Routers 2010 Hardware Installation Guide
1-4
summarizes the interface ports built into the router chassis.
Summary of Cisco 2010 CGR Built-In Interfaces
Data Ports
10/100/1000
100/1000
GE RJ-45
SFP
2
2
GE Ports, page 1-4
SFP Ports, page 1-4
GLC-FE-100FX-RGD=
GLC-FE-100LX-RGD=
GLC-SX-MM-RGD=
GLC-LX-SM-RGD=
GLC-ZX-SM-RGD=
Always use the RJ-45 port.
Always use the SFP port.
for driver installation instructions.
Console,
USB Type A
Serial, RJ-45
2
1
"Installing the Cisco Microsoft Windows USB Device Driver"
Chapter 1
Overview of the Router
Management Ports
Console,
Auxiliary,
Mini-USB (Type B)
RJ-45
1
1
OL-21559-01