Completing The Configuration - Cisco 2010 Hardware Installation Manual

Performing the Initial Configuration on the Router
no shutdown
ip address 10.10.10.12 255.255.255.0
!
end
Respond to the following prompts. Select [2] to save the initial configuration:
Step 10
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started! RETURN
The user prompt is displayed:
myrouter>

Completing the Configuration

When using the Cisco Setup, and after you have provided all the information requested by the facility,
the final configuration appears. To complete your router configuration, follow these steps:
The facility prompts you to save the configuration.
•
•
Use this configuration? {yes/no} : yes
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
%LINK-3-UPDOWN: Interface Ethernet0/0, changed state to up
%LINK-3-UPDOWN: Interface Ethernet0/1, changed state to up
%LINK-3-UPDOWN: Interface Serial1/0, changed state to up
<Additional messages omitted.>
When the messages stop appearing on your screen, press Return to get the Router> prompt.
Step 1
Note
%AT-6-ONLYROUTER: Ethernet0/0: AppleTalk port enabled; no neighbors found
The Router> prompt indicates that you are now at the command-line interface (CLI) and you have just
Step 2
completed a initial router configuration. Nevertheless, this is not a complete configuration. At this point,
you have two choices:
•
Cisco Connected Grid Routers 2010 Hardware Installation Guide
4-6
If you answer no, the configuration information you entered is not saved, and you return to the router
enable prompt (Router#). Enter setup to return to the System Configuration Dialog.
If you answer yes, the configuration is saved, and you are returned to the user EXEC prompt
(Router>).
If you see the next message, it means that no other routers were found on the network attached
to the port.
Run the setup command facility again, and create another configuration.
Chapter 4 Configuring the Router
OL-21559-01