Installing The Cisco Microsoft Windows 2000 Usb Driver; Installing The Cisco Microsoft Windows Vista Usb Driver - Cisco 2010 Hardware Installation Manual

Installing the Cisco Microsoft Windows USB Device Driver
R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
Obtain the file Cisco_usbconsole_driver.zip from www.cisco.com website and unzip it.
Step 1
If using 32-bit Windows XP, double-click the file setup.exe from the Windows_32 folder. If using 64-bit
Step 2
Windows XP, double-click the file setup(x64).exe from the Windows_64 folder.
The Cisco Virtual Com InstallShield Wizard begins. Click Next.
Step 3
The Ready to Install the Program window appears. Click Install.
Step 4
The InstallShield Wizard Completed window appears. Click Finish.
Step 5
Connect the USB cable to the PC and router USB console ports (see
Step 6
USB console port turns green, and within a few moments the Found New Hardware wizard appears.
Follow the instructions to complete the installation of the driver.
The USB console is ready for use.
Step 7

Installing the Cisco Microsoft Windows 2000 USB Driver

This procedure shows how to install the Microsoft Windows 2000 USB driver.
Obtain the file Cisco_usbconsole_driver.zip from www.cisco.com and unzip it.
Step 1
Step 2 Double-click the file setup.exe.
Step 3 The Cisco Virtual Com InstallShield Wizard begins. Click Next.
Step 4 The Ready to Install the Program window appears, Click Install.
The InstallShield Wizard Completed window appears. Click Finish.
Step 5
Step 6 Connect the USB cable to the PC and router USB console ports (see
USB console port turns green, and within a few moments a series of Found New Hardware wizard
windows appear. Follow the instructions to complete the installation of the driver.
Step 7 The USB console is ready for use.

Installing the Cisco Microsoft Windows Vista USB Driver

This procedure shows how to install the Microsoft Windows Vista USB driver.
Obtain the file Cisco_usbconsole_driver.zip from www.cisco.com and unzip it.
Step 1
If using 32-bit Windows Vista, double-click the file setup.exe from the Windows_32 folder, or if using
Step 2
64-bit Windows Vista, double-click the file setup(x64).exe from the Windows_64 folder.
The Cisco Virtual Com InstallShield Wizard begins. Click Next.
Step 3
The Ready to Install the Program window appears, Click Install.
Step 4
If a User Account Control warning appears, click "Allow - I trust this program..." to proceed.
Note
The InstallShield Wizard Completed window appears. Click Finish.
Step 5
Cisco Connected Grid Routers 2010 Hardware Installation Guide
3-14
Chapter 3 Installing and Connecting the Router
Table 3-1). The EN LED for the
Table 3-1). The EN LED for the
OL-21559-01