Component Placement; Wiring Harness Quick Reference - Marksman X6 Installation Manual

Component Placement

Windshield Receiver/Antenna
• The combination windshield receiver/antenna mounts on the windshield (inside).
• We suggest you mount it on the lower or upper left-hand side of the windshield.
Warning! Do not mount in such a manner that it obstructs the driver's view.
• The receiver/antenna whip can be vertical or horizontal.
1. Remove the protective tape backing.
2. Carefully align the receiver/antenna and apply to windshield.
3. Route the black connecting cable behind the trim and connect to receiver/antenna.
4. Connect the other end to the control module.
Mount the antenna horizontally for
best reception.
Valet Switch
Select a mounting location for the switch that is easily accessible to the driver of the vehicle. The switch does
not have to be concealed, however, concealing the switch is always recommended, as this provides an even
higher level of security to the vehicle. Mount the valet switch in a hidden but accessible location. Route the valet
switch wires to the control module.

Wiring Harness Quick Reference

HC1 6-Pin Remote Start Harness
4
Violet
Red +12VDC Battery Input #1
Red +12VDC Battery Input #2
Yellow
Brown +ACC / Heater-Air Conditioner Output
Pink
Remote Starter Output
+Ignition 1 Output
+Ignition 2 / ACC 2 Output