Component Installation - Marksman M9A Installation Manual

Component Installation

Windshield Receiver/Antenna
• The combination windshield receiver/antenna mounts on the windshield (inside vehicle).
• We suggest you mount the receiver/antenna on the lower left-hand side of the windshield.
Warning! Do not mount the Windshield Receiver/Antenna in such a manner that it obstructs
the driver's view.
• The receiver/antenna can be mounted vertical or horizontal.
• Remove the protective tape backing.
• Carefully align the receiver/antenna and apply to windshield.
• Route the black connecting cable behind the trim and connect to receiver/antenna.
• Connect the other end to the control module.
Valet Switch
Select a mounting location for the switch that is easily accessible to the driver of the vehicle. The switch does
not have to be concealed. However, concealing the switch is always recommended, as this provides an even
higher level of security to the vehicle. Mount the valet switch in a hidden but accessible location. Route the
valet switch wires to the control module.
LED Status Indicator
The LED status indicator should be mounted in a highly visible area. Leave at least 6mm of space behind the
mounting location for LED housing. Once a suitable location is chosen, drill a 1/4" hole. Run the LED wires
through the hole then press the 2-pin LED housing into the place. Route the LED wires to the control module.
Wiring
White 6-Pin Heavy Gauge Connector
The method that the remote starter uses to start the vehicle is a duplicate of the ignition switch function. Below, is
an explanation of the 3 basic functions of the ignition switch. Since this installation will require analysis of the
ignition switch functions, it is recommended making the three connections below at the ignition switch harness
directly.
Violet Wire:
(Starter Output)
Careful consideration for the connection of this wire must be made to prevent the vehicle from starting while
in gear. Understanding the difference between a mechanical and an electrical Neutral Start Switch will allow
you to properly identify the circuit and select the correct installation method. In addition you will realize why
the connection of the safety wire is required for all mechanical switch configurations.
Failure to make this connection properly can result in personal injury and property damage.
In all installations it is the responsibility of the installing technician to test the remote start unit and assure
that the vehicle can not start via RF control in any gear selection other than park or neutral.
Violet Wire Starter Output
Red Wire +12 V Input (Battery)
Red Wire +12 V Input (Battery)
Yellow Wire Ignition 1 Output (Must Connect)
Pink Wire Ignition 2 Output
Brown Wire ACC / Heater Output
3