Table of Contents
Advertisement
The duration has elapsed
Setting tips:
Changing the end time
Cancelling the end time
Setting the clock
Following a power failure
36
3. Press the 0 button to close the time setting
options menu.
4. Confirm with the † button.
The setting is adopted. The oven is in standby, the y
end time is displayed in the status bar. Operation
starts at the appropriate time. The x duration is
shown counting down in the status bar.
A signal sounds. The oven stops heating.
The duration shown in the status bar is x 0:00.
You can cancel the signal earlier by pressing the
0 button.
This is possible, providing the oven is on standby.
Open the menu by pressing the 0 button, move to
the end time using the ¿ or ¾ button and change the
end time using the rotary selector. Press the 0 button
to close the menu.
This is possible, providing the oven is on standby.
Open the time setting options menu using the
0 button. Press the ¿ or ¾ button to move to the
end time. Press and hold the 0 button for approx.
4 seconds until the display goes out. The duration
immediately starts to count down.
The oven must be switched off before you can set or
change the clock.
Set clock" appears in the status bar following a
power failure.
1. Turn the rotary selector to set the current time.
The display language set is displayed in the settings
area on the right hand side. This does not change
following a power failure.
2. Press the 0 button.
The time is applied.
Advertisement
Table of Contents
