Pairing 3D Glasses; Wearing And Viewing With The 3D Glasses; Range For Viewing 3D Images - Epson EH-LS10500 User Manual

Laser home projector
Table of Contents

Advertisement

Basic Operations
Attention
Only connect to an electrical outlet that uses the voltage displayed on the adapter.
Note the following points when handling the supplied microUSB cable.
- You should not bend, twist, or pull the cable with too much force.
- You should not modify the cable.
- You should not perform wiring near an electric heater.
- You should not use the cable if it is damaged.

Pairing 3D Glasses

To view 3D images, the 3D Glasses need to be paired with the projector.
Press the [Pairing] button for a while on the 3D Glasses to start pairing. See the User's Guide for the 3D Glasses
for more information.
c
For 3D Glasses that have not been used, pairing is performed when the 3D Glasses are turned on. You
do not need to perform pairing if 3D images can already be viewed correctly.
Once pairing has been performed, you can view 3D images the next time the devices are turned on.
You can perform pairing within a range of three meters from the projector. While pairing is being
performed, make sure you stay within a range of three meters from the projector. Otherwise, pairing
may not be performed correctly.
If synchronization cannot be performed within 30 seconds, pairing is automatically canceled. When
pairing is cancelled, 3D images cannot be viewed because pairing fails.

Wearing and viewing with the 3D Glasses

a
Turn on the 3D Glasses by sliding the
[Power] switch to On.
The indicator turns on for several seconds,
and then turns off.

Range for Viewing 3D Images

This projector allows you to view 3D images within the range shown in the figure below.
You can view 3D images within a range of 10 m from the projector.
b
Put on the 3D Glasses and enjoy the
show.
c
When you have finished using the
3D Glasses, turn them off by
sliding the [Power] switch to Off.
If the 3D Glasses are not used for
at least 30 seconds, they turn off
automatically. To turn the 3D
Glasses back on, slide the
[Power] switch to Off, and then
slide it back to On.
You need more pairs of 3D
Glasses if more than one person
will be viewing the 3D image.
s
39
p.97

Advertisement

Table of Contents
loading

Table of Contents