Troubleshooting
Indicators
Standby condition
Standby condition
(Standby Mode is set to
Communication On.)
(blue)
Warm-up in progress
Cool-down in progress
(blue)
Projection in progress
(blue)
c
•
Under normal operating conditions, the
•
When the Illumination function is set to Off, all indicators are off under normal projection conditions.
Settings - Operation - Illumination
s
When the Indicators Provide No Help
Check the problem
Check the following table to see if your problem is mentioned, and go to the appropriate page for information
on handling the problem.
Status
When you press the
button on the control panel, projection starts.
When you press the
button on the control panel, projection starts.
The power-off operation is disabled while the projector is
warming-up.
All operations are disabled while the projector is cooling-
down. The projector enters standby condition when cool-
down is complete. If for any reason the power cord is discon-
nected during cool-down, wait until the projector has cooled
down sufficiently, reconnect the power cord, and then press
the
the control panel.
The projector is operating normally.
and
o
p.73
85
Remedy
button on the remote control, or the
button on the remote control, or the
button on the remote control, or the
indicators are off.
button on