Pairing 3D Glasses - Epson EH-TW6700W User Manual

Useful Functions
c
•
You can only charge the 3D Glasses
ELPGS03.
•
Make sure you use the USB cable
supplied for the 3D glasses.
•
You can use the glasses for
approximately three hours after
charging for just three minutes. A full
charge takes 50 minutes and the glasses
can be used for approximately 40 hours.
•
You can also charge by connecting the
3D Glasses to the projector. When using
the projector to charge the 3D glasses,
connect the USB charging cable to the
projector's USB port. (Only when the
projector is turned on.)
Attention
•
Only connect to an electrical outlet that uses the voltage displayed on the adapter.
•
Note the following points when handling the USB cable.
- You should not bend, twist, or pull the cable with too much force.
- You should not modify the cable.
- You should not perform wiring near an electric heater.
- You should not use the cable if it is damaged.

Pairing 3D Glasses

To view 3D images, you first need to pair the 3D Glasses with the projector.
Press the [Pairing] button for a while on the 3D Glasses to start pairing. See the User's Guide for the 3D Glasses
for more information.
c
•
When using the 3D Glasses for the first time, pairing is performed when the 3D Glasses are turned on.
You do not need to perform pairing if 3D images can already be viewed correctly.
•
Once pairing has been performed, you can view 3D images the next time the devices are turned on.
•
You can perform pairing within a range of three meters from the projector. While pairing is being
performed, make sure you stay within a range of three meters from the projector. Otherwise, pairing
will fail.
•
If synchronization cannot be performed within 30 seconds, pairing is automatically canceled. When
pairing is cancelled, 3D images cannot be viewed because pairing fails.
51