Connecting The Power Adapter; Connecting Your Computer To The I38Hg; Connecting Directly - Pace i3822V Installation Manual

Connecting the power adapter

To connect the power adapter:
1. Connect one end of the power adapter to the POWER port of your i38HG.
2. Connect the other end of power adapter to a working electrical outlet.
3. Observe the
POWER
remains solid green.
4. Check the NID, BROADBAND, and SERVICE indicators. They light green when
communication is established between the i38HG and i3822V (usually within one
minute).

Connecting your computer to the i38HG

There are two ways to connect your computer to the i38HG: through Ethernet or
wireless. With either connection, the first computer you connect to the network is used
to configure the i38HG for proper operation.

Connecting directly

You can connect up to four computers to the i38HG using the Ethernet connection.
to connect directly through Ethernet:
1. Connect one end of the Ethernet cable (yellow) to any available ETHERNET port
(yellow) on the i38HG.
2. Connect the other end of the Ethernet cable to the computer's Ethernet port. You
are now ready to start your system.
Note: The Ethernet cable is supplied by your service provider. Use a Cat 5 cable if
you need an additional or longer Ethernet cable.
Computer
Ethernet
connection
Chapter 5 Installing the i38HG (Inside Unit)
indicator; it flashes red once, followed by flashing green, then
i38HG
43