Disabling The Alert - Pace i3822V Installation Manual

5. Remove the old battery from the housing and put it safely aside.
6. After removing the old battery, verify that the BATTERY indicator is completely
7. Insert the new battery gently into the housing.
8. Connect the battery cable connector to the battery cable.
9. Observe the BATTERY indicator on the iPSU, it should light green when the
10. Secure the battery with the safety strap.
11. Place the housing cover over the unit and press gently on it until it snaps into
12. Fasten the cover with the two screws you removed earlier.
Note: If you have disabled the alert earlier, make sure to enable the alert.

Disabling the alert

By default, the audible alert is enabled to warn you when the battery is exhausted. It is
recommended that you do not disable the audible alert unless you intend to replace
the battery within a short time. A chirping tone sounds when the battery is exhausted
and needs replacing. The duration of the chirping sound is 0.2 seconds and it
happens once every five seconds. You can turn off the chirping sound to disable the
alert for 12 hours or permanently.
36 Chapter 4
Note: Be careful when removing the battery; it is heavy.
extinguished (not green or blinking red).
Note: It can take up to three minutes before the BATTERY indicator is completely
off and the Power Supply Unit is ready to accept the new battery.
Note: Be sure to place the battery inside the raised bottom edge of the case.
i38HG and i3822V are communicating properly.
Note: A faulty battery is indicated if the BATTERY indicator does not light green
within five minutes (assuming the iPSU is plugged into a functioning AC power
outlet).
place.
Verifying the i3822V and iPSU Installations
Attach safety strap