Connecting The Power Cables; Connecting The Power Supply To The I3822V - Pace i3822V Installation Manual

Connecting the power cables

After the iPSU is mounted, connect the following three sets of cables to begin
supplying power to the i3822V:
•
The power line between the iPSU and i3822V
•
The AC power cord to the AC outlet
•
The battery cable

Connecting the power supply to the i3822V

To connect the iPSU unit to the i3822V:
1. Use a Phillips screwdriver to unfasten the screw securing the power terminal
cover.
2. Insert the end of the power cable from the i3822V through the round opening on
the right panel of the iPSU.
3. Strip 3/8" to 5/8" on the power cable pair to expose the wires.
4. Connect the color-coded wires that correspond to the color-coded binding posts of
the power terminals to the outside unit.
Note: Make sure to maintain polarity: red is positive, black is negative. If the wires
are reversed, the i3822V will not power up.
5. Place the cover back on the power supply post and make sure that it is properly
seated.
Note: Do not pinch the wires.
6. Fasten the screw to secure the power terminal cover.
Chapter 3 Installing the iPSU (Power Supply Unit)
POWER
BATTERY
SILENCE ALARM
CA UTI ON
POTE NTIA L SHO CK
Power terminal cover
Opening
27