Enabling The Ethernet Port - Pace i3822V Installation Manual

Indicators
COAX
LINE 1 and LINE 2
ETHERNET
BATTERY

Enabling the ETHERNET port

The ETHERNET port is disabled by default. This port is used only if the subscriber has
Cat 5 wiring throughout the home that is terminated on the side of the home. It
supports other Ethernet devices, such as switches or hubs.
To enable the ETHERNET port:
1. Open a browser and enter http://gateway.2wire.net or http://172.17.0.1 as the
URL.
2. On the Settings tab, click the LAN tab, and then click Wired Interfaces.
3. Click the Auto MDIX check box to enable the ETHERNET port on the i3822V.
4. Click Save.
Chapter 4 Verifying the i3822V and iPSU Installations
Description
• Solid green. A device is connected (such as a set-top
box).
• Flashing green. There is inbound activity associated with
the COAX port. The flickering of the light is synchronized
to the actual data traffic.
• Red. A device failed to be authenticated or successfully
connected.
• Solid green. The associated voice line has been
registered with the network and is ready for use.
• Flashing green. A phone is in use on the associated
voice line.
These two indicators mirror LINE 1 and LINE 2 indicators
on the i38HG.
• Solid green. A device (such as a computer) is connected
to the ETHERNET port.
• Flashing green. There is inbound activity from devices
connected to the ETHERNET port. The flickering of the
light is synchronized to the actual data traffic.
• Solid green. The AC power is connected and healthy.
• Flashing red. The backup battery is being used for
power.
31