Rheem 96P series Installation Instructions Manual page 25

8
1/8" DRILL
DISCARD
7/8" PLUG
LEFT DRAIN OPTION
DETERMINE RIGHT OR LEFT DRAIN OPTION.
LOCATE 7/8" HOLE IN JACKET SIDE REMOVE PLUG - DISCARD.
DRILL (2) 1/8" HOLES FOR THE BULKHEAD COUPLING.
9
INSTALL BULKHEAD COUPLING USING (2) SCREWS.
INSTALL IN JACKET WITH THE BARBED FITTING POINTED INTO
COVER PLATE
10
"BOTTOM"
PVC GLUE JOINT
10a - INSTALL INTAKE PIPE
SLIDE INTAKE PIPE THRO OUGH THE LEFT SIDE KNOCKOUT ON
10b - INSTALL FLUE PIPE ASSE EMBLY
INSERT FLUE PIPE ASSE MBLY THROUGH RIGHT SIDE KNOCK
SLIDE ANGLED END THRO OUGH OPENING IN BLOWER SHELF A
SECURE PIPE ASSEMBLY TO BLOWER SHELF WITH (2) SCREWS AS SHOWN. ENSURE O-RING IS P
10c - SLIDE PIPE COLLAR ASSEMBLIES FROM STEP 7 OVER THE (2) PIPES AND DRILL (8)
ø1/8" HOLES USING THE COLLARS AS TEMPLATES. SECURE WITH SCREWS.
O THE VESTIBULE.
10a
N COVER PLATE CLEAN AND PVC GLU
KOUT ON COVER PLATE (NOTE: SLIDE
AND ALIGN WITH ELBOW COUPLING.
RIGHT DRAIN OPTION
PRE-DRILL 1/8"
HOLES AND
ATTACH W/SCREWS
(2) PLACES
X10
O-RING
INSTALL
SCREWS
10b
UE TO INTAKE COUPLING AS SHOWN
E FROM UNDER PLATE).
PROPERLY SEATED.
1/8" DRILL
DISCARD
7/8" PLUG
10c
ST-A1194-31-04
25