Rheem 96P series Installation Instructions Manual page 19

DO OWNFLOW W/ RIGHT VENT (N
PARTS NEEDED: PARTS NEED ED:
FROM PARTS BAG (PROVIDED WITH UNIT) WITH UNIT)
(X3)
(X2)
HOSE
#8 X 1/2"
CLAMP
SCREW
FROM CONVERSION KIT RXGY-CK RXGY-CK
2" PIPE GROMMET
2-5/8" FLUSH
( 3.375)
MOUNT PLUG
TOOLS/MATERIALS NEEDED:
DRILL
(1) 1/8 DRILL BIT (1) 1/8" DRILL BIT
NOTE: THESE CONVERSION INSTRUCTIONS ARE INTEN
NOTE: STEPS 1- 5 SHOWN WITH FURNACE IN "AS SHIPP
1
1a
1b
1a - REMOVE FLUE TRANSITION N, TRANSITION COUPLING, AND EL
(NOTE: REMOVE COUPLING O ON INDUCER WITH ELBOW FOR EA
1b - REMOVE TRAP AND HOSES. RETAIN HOSE D FOR LATER USE
(NOTE:TO REMOVE TRAP REMOVE (2) SCREWS AND PULL STRA
PARTS NEEDED FOR THIS CONVERSION RE
FROM THE PARTS BAG AND CONVERSION K
!
YOU MUST HAVE THE PARTS OUTLINED BE
PROCEEDING.
HOSE -
DOUBLE
ELBOW
TUBE C
(X4)
CONDENSATE
#8 X 1/2"
TRAP DRAIN
SCREW
PLUG .559"
(1) 3/16" DRILL BIT
PLIERS PLIERS
TIONALLY GENERIC, SOME PARTS MAY BE DIFFERENT IN
PED CONDITION"
FLUE TRANSITION (D DISCARD)
TRANSITION T
COUPLING C
( DISCARD)
ELB BOW (DISCARD)
ID DB COUPLING
(R RETAIN)
VENT HOSE V
( DISCARD)
HO OSE "D"
(RE ETAIN)
BOW.
ASIER REMOVAL).
E.
AIGHT OUT).
NON-ZERO CLEARANCE)
EQUIRE ITEMS
KIT RXGY-CK.
LOW BEFORE
INTAKE AIR
INTAKE
C COUPLING
DIFFUSER
W/ NUT
1/2" DRAIN
5/8" DRAIN
HOSE E
HOSE B
(1) 1/4" HEX HEAD DRIVER
(1) 5/16 HEX HEAD DRIVER (1) 5/16 HEX HEAD DRIVER
2
2-5/8"
2d
DISCARD
2a
NOTE:
IF THE IDB COUPLING IS
REMOVED, IT MUST BE
REPLACED IN THE PROPER
ORIENTATION. AN ARROW IS
PRESENT ON THE COUPLING
TO INDICATE THE DIREC-
TION OF EXHAUST FLOW.
MAKE SURE THE ARROW
POINTS IN THE CORRECT
DIRECTION.
2a-REMOVE 3-3/8" FLUSH MOUNT PLUG FROM JACKET - DISCARD.
2b-RELOCATE 2-3/8" FLUSH MOUNT PLUG FROM JACKET TO TOP PLATE.
2c-RELOCATE 1/2" VINYL CAP (YELLOW) IN INDUCER COUPLING.
2d-INSTALL 2-5/8" FLUSH PLUG IN TOP PLATE.
BULKHEAD
COUPLING
CONDENSATE
1/4" BLACK
TRAP BRACKET
VENT TUBE
(DOWN FLOW)
FLAT HEAD SCREWDRIVER
TUBING CUTTER
YOUR FURNACE
INSTALL
2c
ST-A1194-30-02
2b
19