Rheem 96P series Installation Instructions Manual page 24

3
INSTALL HOSE E ON COLLECTO OR BOX AS SHOWN.
LET THE OPEN END HANG FREE E UNTIL STEP 11.
NOTE:
USE SOAPY WATER TO FACILIT TATE EASY HOSE AND TUBE ASSEM
NOTE: REMAINING STEPS SHOWN W/ FU
5
ROTATE
UNIT 5a
5a - ROTATE UNIT 180°
5b - REMOVE KNOCKOUTS W WITH HAMMER AND FLAT HEAD SCRE
5c - THE JUNCTION BOX WILL L HAVE TO BE RELOCATED FOR FLUE
SEE ELECTRICAL WIRING G SECTION FOR INSTRUCTIONS.
5d - RE-DRILL (2) Ø1/8" HOLES S IN BLOWER SHELF AS SHOWN FOR
5 5e - PRE-DRILL (2) Ø3/16" HO PRE DRILL (2) Ø3/16" HO LES IN JACKET AS SHOWN FOR CONDENSATE TRAP BRACKET. LES IN JACKET AS SHOWN FOR CON
6
DIFFUSER
FULLY SEATED
INSTALL INTAKE COUPLING IN BLOWER BLOWER
SHELF HOLE AS SHOWN.
INSERT AIR DIFFUSER INTO COUPLING
UNTIL TABS ARE SEATED.
24
4
4a
4a - RE-INSTALL ELBO OW AND COUPLINGS (REMOVED IN S
ORIENTATION AS
4b - RELOCATE 1/2" V VINYL CAP (YELLOW) ON INDUCER CO
OPPOSITE SIDE.
BLY NOTE: LEAVE CO OUPLING CLAMP CONNECTIONS LOO
URNACE IN DOWN FLOW ORIENTATION
R REMOVE KNOCKOUTS 5b
RELOCATE JUNCTION BOX AND DOOR SWITCH R
S EE ELECTRICAL WIRING SECTION
F OR INSTRUCTIONS
5c 5
DRILL (2) 3/16" HOLES 5e
EWDRIVER.
E PIPE INSTALLATION.
R FLUE PIPE ASSEMBLY.
NDENSATE TRAP BRACKET.
7
7b
.559
DRAIN PLUG
7a - REMOVE THE SM 7a - REMOVE THE SMALL MOUNTING BRACKET AND THE .4
7b - INSTALL .559" DRA 7b - INSTALL .559" DRAIN PLUG IN CONDENSATE TRAP.
7c - INSTALL DOWN F 7c - INSTALL DOWN FLOW CONDENSATE TRAP BRACKET W
N NOTE:
I F THE IDB COUPLING IS
REMOVED, IT MUST BE R
R REPLACED IN THE PROPER
O ORIENTATION. AN ARROW IS
P PRESENT ON THE COUPLING
TO INDICATE THE DIREC- T
TION OF EXHAUST FLOW. T
MAKE SURE THE ARROW M
P POINTS IN THE CORRECT
DIRECTION. D
4b
TEP 1) IN THE
SHOWN.
OUPLING TO
OSE UNTIL STEP 11.
DRILL (2)
1/8" HOLES
IN BLOWER
SHELF
5d
(X2)
DISCARD
7a
7 c
403" DRAIN PLUG - DISCARD.
WITH (2) SCREWS AS SHOWN.
ST-A1194-31-04