HP ProLiant DL360 Gen10 User Manual page 9

Item Description
1 UID button/LED*
2 Power On/Standby button and
system power LED*
3 Health LED*
4 NIC status LED*
*When all four LEDs described in this table flash simultaneously, a power fault has occurred.
**Facility power is not present, power cord is not attached, no power supplies are installed, power supply
failure has occurred, or the power button cable is disconnected.
†If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the
system health status.
Status
Solid blue = Activated
Flashing blue:
• 1 Hz = Remote management or firmware upgrade in
progress
• 4 Hz = iLO manual reboot sequence initiated
• 8 Hz = iLO manual reboot sequence in progress
Off = Deactivated
Solid green = System on
Flashing green = Performing power on sequence
Solid amber = System in standby
Off = No power present**
Solid green = Normal
Flashing green = iLO is rebooting
Flashing amber = System degraded
Flashing red = System critical†
Solid green = Link to network
Flashing green = Network active
Off = No network activity
Component identification 9