Table of Contents
Advertisement
Universal media bay options
Installing a 2 SFF SAS/SATA drive cage
Prerequisites
Universal media bay options are compatible only with the 8 SFF chassis.
Hewlett Packard Enterprise recommends installing the P816i-a controller to support 10 SAS/SATA drives. For
more information, see Installing an HPE Smart Array P816i-a Controller option on page 87.
Additional controller options are available. For more information, see the HPE DL360 Gen10 Server cabling
matrix on the Hewlett Packard Enterprise website (http://www.hpe.com/info/CablingMatrixGen10).
In addition, be sure that you have the following:
•
The components included with the hardware option kit
•
T-10 Torx screwdriver
•
Additional cables, as needed. For more information, see SFF cables on page 114.
•
2 SFF SAS or SATA drives or blanks
For more information, contact a Hewlett Packard Enterprise authorized reseller.
Procedure
1.
Back up all server data.
2.
Power down the server (Power down the server on page 24).
3.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4.
Do one of the following:
a. Extend the server from the rack (Extend the server from the rack on page 24).
b. Remove the server from the rack (Remove the server from the rack on page 25).
5.
Remove the access panel (Remove the access panel on page 25).
6.
Remove the universal media bay blank.
52
Universal media bay options
Advertisement
Table of Contents
