Malfunctions Shown On The Display (For The User) - Smeg UG405DSUK User Manual

11 MALFUNCTIONS SHOWN ON THE DISPLAY (FOR THE USER)

The dishwasher can show a series of malfunctions on display.
After the machine has been switched off and restarted, if the problem is not solved, follow the steps
below:
( FOR A MORE PROFICIENT AFTER-SALES SERVICE, ALWAYS TAKE NOTE OF THE INDICATED ERROR )
Err04 Tank temperature probe anomaly
Tank water filling anomaly
Err05
Water pump-out anomaly
Err06
(water remains in the dishwasher)
Err09 Excessive water level in the tank anomaly
Err23 Boiler heating anomaly (does not heat)
Err24 Boiler temperature probe anomaly
Err25 Boiler water filling anomaly
Err26 Boiler emptying anomaly
Err27 Boiler emptying anomaly – with full tank
Err28 Boiler heating anomaly (over temperature)
Contact After-sales Service
Check that the water supply tap is open, the dynamic supply
pressure, cleanliness of the inlet water filter. If the problem
still occurs, contact After-sales Service.
Check that the filters are clean, and that the drain pipe is not
bent, obstructed, narrowed.
Check that the drain pump is not blocked with a foreign body,
follow steps indicated in "10.2 Periodical checks".
If the problem still occurs, contact After-sales Service.
Contact After-sales Service
Contact After-sales Service
Contact After-sales Service
Check that the water supply tap is open, the dynamic supply
pressure, cleanliness of the inlet water filter. If the problem
still occurs, contact After-sales Service.
Check that the nozzles of the rinsing spray arms are not
clogged.
If the problem still occurs, contact After-sales Service.
Contact After-sales Service
Contact After-sales Service
25