Table of Contents
Advertisement
6.10
"Clean water cycle" option - Display reads "CL
6.11
"Thermostop" option - Display reads "tS tS tS tS"
6.12
Fast/eco starting option - Display reads "F F F F i"
7
MALFUNCTIONS SHOWN ON THE DISPLAY (FOR THE TECHNICIAN)
The dishwasher is able to identify a number of malfunctions and show them on the display. If the problem persists after the
dishwasher has been switched off and back on, proceed as described below:
Tank temperature probe
Er 04
malfunction
Tank water filling malfunction
Er 05
Water pump-out malfunction
Er 06
Boiler does not heat up as expected.
Er 23
CL"
CL
CL
With this option clean water is used for every washing. At each cycle,
the washing water is completely drained and it is replaced with clean
water from rinsing.
Press
"on" = the minimum temperature of rinse as set, independently from
the intake water temperature, the nominal duration of cycle may be
extended by a few seconds.
"off" = the minimum temperature of rinse may be a few degrees lower
than the set one, if hot intake water is not used.
Press
Fast (FS): it allows to start the machine in less time than the standard;
it involves a greater water consumption at the first start.
Eco starting (EC): the machine starts in standard time, without any
additional water consumption.
Press
Tank temperature probe disconnected or not working.
- The tank wasn't filled in the expected time: check the water supply tap, the
dynamic supply pressure, cleanliness of the inlet water filter, cleanliness of the
rinse nozzles, any damage of the water charging hose. If the problem still
occurs during the "FILL":
- Work level tank pressure switch damaged (it always detects "empty": check if
the tank safety pressure switch starts operating).
- Leakage from the tube connected to the air trap; if the problem is not solved,
it occurs during the work program.
- vent valve of the drain pipe obstructed with dirt: with siphonage, the tank
gets completely empty at the end of a washing program.
Check:
- filter cleanliness; obstructions, bending and narrowing of the drain pipe.
- possible obstructions of the drain pump (blocked with a foreign body).
In case the problem is not solved, please contact the After-Sales Service.
The problem might occur because water is continually entering the tank (the
causes are as for "Er 05" – see above) If the boiler heating element is
damaged, this might be due to operation with no water in the boiler - the
13
to enable (On)/disable (OF)
to enable (On)/disable (OF)
to enable (On)/disable (OF)
Hide quick links:
Advertisement
Table of Contents
