Choosing The Program; Changing The Program - Smeg UG405DSUK User Manual

When the door is closed again, the system offers the last program run.

8.4 Choosing the program

SYMBOL
Short
Medium
Long
(*) The cycle duration stated above is guaranteed if the appliance is connected to hot water > 50°C <60°C
If the dishwasher is supplied with cold water, the cycle duration might increase depending on the intake water temperature
and the "Thermostop" setting.
If the door is opened when a program is in progress, the program is interrupted; when the door is closed again
the program must be restarted.
Power failure.
If the door is open when power is restored, the display reads "CLOSE" and "°t" flashes; the heating element stays
off for the user's safety, in order to avoid the risk of burns.
Close the door to resume heating the water in the tank.

8.5 Changing the program

If a programme is already running, it can be changed by first switching the appliance to pause status (by pressing one of the
buttons for 2") and then selecting the programme required.
PROGRAM
If the master switch is not turned off, the appliance sets on the last
programme performed. To change the program, press the button of
the desired program, the led flashes and the display reads the
program duration.
To confirm hold down for about 2". The led flashes and the wash
program starts.
18
TYPE OF DIRT
Glasses and cups
Glasses, cups and plates with light dirt
Very dirty dishes and cutlery
DURATION (*)
2'
2'30"
3'