Assembling The Front Wheel; Adjusting The Front Wheel Static Balance - Yamaha Star XVS13AA(C) 2011 Service Manual

• Lateral wheel runout "2"
Over the specified limits → Replace.
Radial wheel runout limit
1.0 mm (0.04 in)
Lateral wheel runout limit
0.5 mm (0.02 in)
4. Check:
• Wheel bearings
Front wheel turns roughly or is loose → Re-
place the wheel bearings.
• Oil seals
Damage/wear → Replace.
EAS21960

ASSEMBLING THE FRONT WHEEL

1. Install:
• Wheel bearings New
• Oil seals New
M MMM M MMM M M MMM M M MMM M
a. Install the new wheel bearings and oil seals in
the reverse order of disassembly.
ECA3D81004
NOTICE
Do not contact the wheel bearing inner race
"1" or balls "2". Contact should be made
only with the outer race "3".
TIP
Use a socket "4" that matches the diameter of
the wheel bearing outer race and oil seal.
M MMM M M MMM M MMM
4-16
L LLL L LLL L L LLL L L LLL L
EAS21970
ADJUSTING THE FRONT WHEEL STATIC
BALANCE
TIP
• After replacing the tire, wheel or both, the front
wheel static balance should be adjusted.
• Adjust the front wheel static balance with the
brake discs installed.
1. Remove:
• Balancing weight(s)
2. Find:
• Front wheel's heavy spot
TIP
Place the front wheel on a suitable balancing
stand.
M MMM M MMM M M MMM M M MMM M
a. Spin the front wheel.
b. When the front wheel stops, put an "X
at the bottom of the wheel.
c. Turn the front wheel 90
is positioned as shown.
d. Release the front wheel.
e. When the wheel stops, put an "X
the bottom of the wheel.
FRONT WHEEL
L LLL L L LLL L LLL
M MMM M M MMM M MMM
" mark
1
°
so that the "X " mark
1
" mark at
2