Yamaha Star XVS13AA(C) 2011 Service Manual page 103

CABLE ROUTING (for XVS13AA(C)/XVS13CTA(C))
1. Rear cylinder thermostat inlet hose
2. Right handlebar switch lead
3. Wire harness
4. Front cylinder resonator hose
5. Canister purge hose (California only)
6. Throttle position sensor
7. Intake air pressure sensor hose
8. Rear cylinder resonator hose
9. Sub-wire harness couplers
10. Fuel hose
11. Injectors
12. Front cylinder thermostat inlet hose
13. Intake air pressure sensor
A. Point the ends of the hose clamp inward.
B. Align the hose clamp with the white paint mark on
the canister purge hose (California only) and point
the ends of the clamp forward.
C. Route the canister purge hose (California only) to
the outside of the front cylinder resonator hose,
and then install it onto the throttle body pipe up to
the bend in the pipe, making sure to face the white
paint mark on the hose upward.
– –
D. 2 4 mm (0.08 0.16 in)
E. Point the ends of the hose clamp outward.
F. Route the canister purge hose (California only)
under the intake air pressure sensor hose.
G. Point the ends of the hose clamp rearward.
– –
H. 0 1 mm (0 0.04 in)
I. Install the intake air pressure sensor hose with its
white paint mark facing outward.
2-76