Show Self-Loop-Discovery; Show Allowed Managers Status - Avaya P332MF User Manual

Chapter 6 CLI – Layer 2
The syntax for this command is:
show arp-aging-interval
Output Example:
P330-N> show arp-aging-interval
ARP table aging interval for gateways was set to 10 minutes.

show self-loop-discovery

Use the show self-loop-discovery command to display a switch's IBM token ring
cable discovery status.
Note: This command is not supported by the P330-ML switches.
Note: If this command is to be implemented on a switch other than the stack master,
a session should be opened to the relevant switch.
The syntax for this command is:
show self-loop-discovery [mod_num]
Output Example:
P330-N> show self-loop-discovery 1
Self-Loop-Discovery is disabled on module 1.

show allowed managers status

Use the show allowed managers status command to display the activation
status of the Allowed Managers feature. When this feature is enabled, only those
stations whose IP addresses are listed in the Allowed Managers table can access the
device over Telnet, SNMP, or HTTP.
The syntax for this command is:
show allowed managers status
Output Example:
P330-N> show allowed managers status
Managers are disabled.
78 Avaya P332MF User's Guide