Table of Contents
Advertisement
WPM System
USER GUIDE
” Lift the first WPM cabinet onto the universal tilt bracket. The lugs on the ends of the main cross-arm should mate with the
slots in the front corners of the cabinet. Secure these points with flying pins.
Fig.42 - insert rigging pin
” Attach the rear lug of the bracket to the Ground Stack hole (marked with a
with a Rigging Pin. Using the rear adjustment knob, set the tilt angle to the correct angle according to the DISPLAY software
prediction; the angle can be seen by observing the calibration hole at the right-hand side.
Fig.44 - attach first cabinet
WPM User Guide v1.0
Fig.43 - insert rigging pin
) in the cabinet's rear mounting plate. Secure
Fig.45 - angle Universal Bracket
Page 47
Advertisement
Table of Contents
