Assembling And Mounting The Unit; Designating The Optional Board; Disconnecting The Unit From The Supply; Installing Optional Boards On Units With A Width Of 135 Mm And 180 Mm - Siemens 6SE7011-5EP60 Operating Instructions Manual

05.2003
Assembling and
mounting the unit
Designating the
optional board
5.2.2 Installing optional boards on units with a width of 135 mm and
180 mm
DANGER
Opening the unit
Siemens AG 6SE7087-6JP60
SIMOVERT MASTERDRIVES
www.aotewell.com
Close the right-hand side wall of the unit as follows
♦ Insert the right-hand side wall from above into the guide on the front
right-hand side.
♦ Swing back the side wall.
♦ Screw the side wall tight again by means of the two fixing screws.
Mount the unit as follows:
♦ Insert the unit into its mounting position from the front underneath
the DC link bus module.
♦ Lift the unit upwards until the DC link bus module is completely in its
original position again.
♦ Screw the unit tight to the mounting surface with the fixing screws.
♦ Interlock the DC bus module.
If you are using an AC unit as a single drive, you can fix the unit directly
to the mounting surface.
♦ Re-connect all previously removed connecting cables.
♦ Check all connecting cables and the shield to make sure they sit
properly and are in the correct position.
♦ To designate the optional board, insert the relevant designation
plate into the envisaged position on the front of the unit.
♦ When the voltage has been switched in, the software of the unit
recognizes which optional boards have been installed and you can
then commence start-up.

Disconnecting the unit from the supply

Disconnect the unit from the power supply and power down the unit.
Remove the 24 V voltage supply for the electronics. Remove all
connecting cables.
♦ Loosen the 2 fixing screws on the front of the unit at the top. There
is no need to remove the screws completely, since cutouts are
provided in the housing to permit the front to come away after the
screws have been loosened.
♦ Carefully swing the upper front section forwards (approx. 30 °) away
from the housing.
♦ At the power section, open the locking lever of the ribbon cable that
connects up with the control electronics.
♦ Take off the front of the unit by moving it forwards.
Operating Instructions
sales@aotewell.com
Industry Automation
Installation
5-7
+86-755-8660-6182