Operating Instructions; Setup; Setting Up The System; Fixture Addressing - Chauvet Obey 10 User Manual

3. O
PERATING

Setup

Setting up the System

1) Place the Obey 10 on a level surface.
2) Plug the AC to DC power supply into the system back panel and into the mains outlet.
3) Plug in your DMX cable(s) to your intelligent lighting as described in the respective fixture's
manual. For a quick overview of DMX see the "DMX Primer" section.
4) Reset the system using the instructions on page 9.

Fixture Addressing

The Obey 10 is programmed to control 16 channels of DMX per fixture. Therefore, the fixtures
you wish to control with the corresponding "FIXTURE" buttons on the unit must be spaced 16
channels apart (check the respective fixture's manual for how to enter the information into the
fixture).
Note: failure to use these DMX assignments may cause a lack of control of the fixtures.
F
IXTURE OR
S
CANNER
1
2
3
4
5
6
7
8
Obey 10 User Manual
I
NSTRUCTIONS
Note! The Obey 10 can also be rack mounted, occupying two rack spaces (2U).
D DMX S
EFAULT TARTING
# A
DDRESS
1
17
33
49
65
81
97
113
B D S
INARY IPSWITCH ETTINGS
S "O
WITCH TO THE N POSITION
1
1,5
1,6
1,5,6
1,7
1,5,7
1,6,7
1,5,6,7
9
"
Rev. 5