Cisco Nexus 6000 Series Configuration Manual page 72

Configuration Examples for FCoE NPV
vfc26
vfc130
switch#
This example shows the running configuration information about FCoE:
switch# show running-config fcoe_mgr
!Command: show running-config fcoe_mgr
!Time: Wed Jan
version 6.0(2)N1(1)
interface vfc1
bind interface Ethernet1/19
interface vfc2
bind interface Ethernet1/2
interface vfc90
bind interface Ethernet1/9
interface vfc100
bind interface Ethernet1/10
interface vfc110
bind interface port-channel110
interface vfc111
bind interface Ethernet1/11
interface vfc120
bind interface port-channel120
interface vfc130
bind interface port-channel130
interface vfc177
bind interface Ethernet1/7
fcoe fka-adv-period 16
This example shows the FCoE VLAN to VSAN mappings:
switch# show vlan fcoe
Original VLAN ID
----------------
400
20
100
500
200
300
This example shows the information about the vFC 130 interface including attributes and status:
switch# show interface vfc 130
vfc130 is trunking (Not all VSANs UP on the trunk)
Bound interface is port-channel130
Hardware is Virtual Fibre Channel
Port WWN is 20:81:00:05:9b:74:bd:bf
Admin port mode is NP, trunk mode is on
snmp link state traps are enabled
Port mode is TNP
Port vsan is 1
Trunk vsans (admin allowed and active) (1,20,100,200,300,400,500)
Trunk vsans (up)
Trunk vsans (isolated)
Trunk vsans (initializing)
1 minute input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
1 minute output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
15 frames input, 2276 bytes
Cisco Nexus 6000 Series NX-OS SAN Switching Configuration Guide, Release 6.x
52
400 NP on trunking
1 NP on trunking
20 21:59:39 2013
Translated VSAN ID
------------------
400
20
100
500
200
300
swl TNP 2
-- TNP auto --
Association State
-----------------
Operational
Operational
Operational
Operational
Operational
Operational
(500)
()
(1,20,100,200,300,400)
Configuring FCoE NPV
--
OL-27932-01