Displaying Port Tracking Information - Cisco Nexus 6000 Series Configuration Manual

Configuring Port Tracking
Procedure
Step 1
Step 2
Step 3
Step 4

Displaying Port Tracking Information

The show commands display the current port tracking settings for the switch.
The following example shows how to display tracked port configuration for a specific interface:
switch# show interface vfc21
vfc21 is down (Administratively down)
5 minutes input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
...
The following example shows how to display tracked port configuration for a SAN port channel:
switch# show interface san-port-channel 1
port-channel 1 is down (No operational members)
...
OL-27932-01
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
switch(config)# interface vfc vfc-id
port-track force-shut
Example:
switch(config-if)# port-track
force-shut
no port-track force-shut
Example:
switch(config-if)# no port-track
force-shut
Hardware is Fibre Channel, FCOT is short wave laser w/o OFC (SN)
Port WWN is 20:01:00:05:30:00:0d:de
Admin port mode is FX
Port vsan is 1
Receive data field Size is 2112
Beacon is turned off
Port tracked with interface vc22 (down)
Port tracked with interface san-port-channel 1 vsan 2 (down)
Hardware is Fibre Channel
Port WWN is 24:01:00:05:30:00:0d:de
Admin port mode is auto, trunk mode is on
Port vsan is 2
Linked to 1 port(s)
Port linked to interface vfc21
Cisco Nexus 6000 Series NX-OS SAN Switching Configuration Guide, Release 6.x
Displaying Port Tracking Information
Purpose
Enters global configuration mode.
Configures the specified interface and enters
the interface configuration mode. You can now
configure tracked ports.
Forcefully shuts down the tracked port.
Removes the port shutdown configuration for
the tracked port.
189