Portal Configuration Examples; Configuring Direct Portal Authentication - HP FlexFabric 5700 Series Security Configuration Manual

Task
Display portal configuration and portal running state
information on an interface.
Display portal authentication server information.
Display portal Web server information.
Display packet statistics for portal authentication
servers.
Display portal user information.
Clear packet statistics for portal authentication
servers.

Portal configuration examples

Configuring direct portal authentication

Network requirements
As shown in
assigned with a public IP address either manually or through DHCP. A portal server acts as both a portal
authentication server and a portal Web server. A RADIUS server acts as the authentication/accounting
server.
Configure direct portal authentication, so the host can access only the portal server before passing the
authentication and access other network resources after passing the authentication.
Figure 40 Network diagram
Configuration prerequisites
Configure IP addresses for the host, switch, and servers as shown in
•
can reach each other.
• Configure the RADIUS server properly to provide authentication and accounting functions.
Configuring the portal authentication server on IMC PLAT 3.20
In this example, the portal server runs on IMC PLAT 3.20-R2602P13 and IMC UAM 3.60-E6301.
1. Configure the portal authentication server:
Figure 40, the host is directly connected to the switch (the access device). The host is
Command
display portal interface interface-type
interface-number
display portal server [ server-name ]
display portal web-server [ server-name ]
display portal packet statistics [ server server-name ]
display portal user { all | interface interface-type
interface-number }
reset portal packet statistics [ server server-name ]
137
Figure 40 and make sure they