HP FlexFabric 5700 Series Security Configuration Manual page 173

# Configure the BAS-IP as 20.20.20.1 for portal packets sent from VLAN-interface 4 to the portal
authentication server.
[SwitchA–Vlan-interface4] portal bas-ip 20.20.20.1
[SwitchA–Vlan-interface4] quit
On Switch B, configure a default route to subnet 192.168.0.0/24, specifying the next hop address as
20.20.20.1. (Details not shown.)
Verifying the configuration
# Verify that the portal configuration has taken effect.
[SwitchA] display portal interface vlan-interface 4
Portal information of Vlan-interface4
Nas id profile: Not configured
IPv4:
Portal status: Enabled
Authentication type: Layer3
Portal Web server: newpt
Authentication domain: Not configured
Bas-ip: 20.20.20.1
User Detection:
Action for server detection:
Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
IPv6:
Portal status: Disabled
Authentication type: Disabled
Portal Web server: Not configured
Authentication domain: Not configured
Bas-ipv6: Not configured
User detection: Not configured
Action for server detection:
Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
Before a user performs portal authentication by using the HP iNode client, the user can access only the
authentication page http://192.168.0.1 1 1:8080/portal. All Web requests the user initiates will be
redirected to the authentication page.
If the user passes the authentication but fails the security check, the user can access only the
•
resources that match ACL 3000.
Not configured
Server name
--
Mask
Mask
Server name
--
161
Action
--
Action
--
Prefix length
Prefix length