HP FlexFabric 5700 Series Security Configuration Manual page 27

No. Attribute
61 NAS-Port-Type
79 EAP-Message
80 Message-Authenticator
87 NAS-Port-Id
HP proprietary RADIUS sub-attributes
No. Sub-attribute
1 Input-Peak-Rate
2 Input-Average-Rate
3 Input-Basic-Rate
4 Output-Peak-Rate
5 Output-Average-Rate
6 Output-Basic-Rate
15 Remanent_Volume
20 Command
24 Control_Identifier
25 Result_Code
Description
Type of the physical port of the NAS that is authenticating the user. Possible
values include:
•
15—Ethernet.
•
16—Any type of ADSL.
•
17—Cable. (With cable for cable TV.)
•
19—WLAN-IEEE 802.1 1.
•
201—VLAN.
•
202—ATM.
If the port is an ATM or Ethernet one and VLANs are implemented on it, the
value of this attribute is 201.
Used to encapsulate EAP packets to allow RADIUS to support EAP
authentication.
Used for authentication and verification of authentication packets to
prevent spoofing Access-Requests. This attribute is present when EAP
authentication is used.
String for describing the port of the NAS that is authenticating the user.
Description
Peak rate in the direction from the user to the NAS, in bps.
Average rate in the direction from the user to the NAS, in bps.
Basic rate in the direction from the user to the NAS, in bps.
Peak rate in the direction from the NAS to the user, in bps.
Average rate in the direction from the NAS to the user, in bps.
Basic rate in the direction from the NAS to the user, in bps.
Total remaining available traffic for the connection, in different units for
different server types.
Operation for the session, used for session control. Possible values
include:
•
1—Trigger-Request.
•
2—Terminate-Request.
•
3—SetPolicy.
•
4—Result.
•
5—PortalClear.
Identification for retransmitted packets. For retransmitted packets from
the same session, this attribute must be the same value. For retransmitted
packets from different sessions, this attribute does not have to be the
same value. The client response of a retransmitted packet must also
include this attribute and the value of this attribute must be the same.
For Accounting-Request packets of the start, stop, and interim update
types, the Control_Identifier attribute does not take effect.
Result of the Trigger-Request or SetPolicy operation, zero for success and
any other value for failure.
15