HP FlexFabric 5700 Series Security Configuration Manual page 166

Verifying the configuration
# Verify that the portal configuration has taken effect.
[Switch] display portal interface vlan-interface 100
Portal information of Vlan-interface100
Nas id profile: Not configured
IPv4:
Portal status: Enabled
Authentication type: Direct
Portal Web server: newpt
Authentication domain: Not configured
Bas-ip: 2.2.2.1
User Detection:
Action for server detection:
Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
IPv6:
Portal status: Disabled
Authentication type: Disabled
Portal Web server: Not configured
Authentication domain: Not configured
Bas-ipv6: Not configured
User detection: Not configured
Action for server detection:
Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
Before a user performs portal authentication by using the HP iNode client, the user can access only the
authentication page http://192.168.0.1 1 1:8080/portal. All Web requests the user initiates will be
redirected to the authentication page.
If the user passes the authentication but fails the security check, the user can access only the
•
resources that match ACL 3000.
After passing both the authentication and the security check, the user can access Internet resources
•
that match ACL 3001.
# After the user passes authentication, use the following command to display information about the
portal user.
[Switch] display portal user interface vlan-interface 100
Total portal users: 1
Username: abc
Not configured
Server name
--
Mask
Mask
Server name
--
154
Action
--
Action
--
Prefix length
Prefix length