HP FlexFabric 5700 Series Security Configuration Manual page 160

[Switch–Vlan-interface100] quit
Verifying the configuration
# Verify that the portal configuration has taken effect.
[Switch] display portal interface vlan-interface 100
Portal information of Vlan-interface100
Nas id profile: Not configured
IPv4:
Portal status: Enabled
Authentication type: Redhcp
Portal Web server: newpt
Authentication domain: Not configured
Bas-ip: 20.20.20.1
User Detection:
Action for server detection:
Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
IPv6:
Portal status: Disabled
Authentication type: Disabled
Portal Web server: Not configured
Authentication domain: Not configured
Bas-ipv6: Not configured
User detection: Not configured
Action for server detection:
Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
A user can perform portal authentication by using the HP iNode client or through Web page. Before
passing the
http://192.168.0.1 1 1:8080/portal and all Web requests will be redirected to the authentication page.
After passing the authentication, the user can access Internet resources.
# After the user passes authentication, use the following command to display information about the
portal user.
[Switch] display portal user interface vlan-interface 100
Total portal users: 1
Username: abc
Portal server: newpt
State: Online
Not configured
Server name
--
Server name
--
authentication, the
Mask
Mask
user can access
148
Action
--
Action
--
Prefix length
Prefix length
only the authentication page