HP FlexFabric 5700 Series Security Configuration Manual page 43

Step
3. Specify a security policy
server.
Configuring the Login-Service attribute check method for SSH, FTP, and terminal users
The device supports the following check methods for the Login-Service attribute (RADIUS attribute 15) of
SSH, FTP, and terminal users:
Strict—Matches Login-Service attribute values 50, 51, and 52 for SSH, FTP, and terminal services,
•
respectively.
Loose—Matches the standard Login-Service attribute value 0 for SSH, FTP, and terminal services.
•
An Access-Accept packet received for a user must contain the matching attribute value. Otherwise, the
user cannot log in to the device.
Use the loose check method only when the server does not issue Login-Service attribute values 50, 51,
and 52 for SSH, FTP, and terminal users.
To configure the Login-Service attribute check method for SSH, FTP, and terminal users:
Step
1. Enter system view.
2. Enter RADIUS scheme view.
3. Configure the Login-Service
attribute check method for
SSH, FTP, and terminal users.
Enabling SNMP notifications for RADIUS
When SNMP notifications are enabled for RADIUS, the SNMP agent supports the following notifications
generated by RADIUS:
RADIUS server unreachable notification—The RADIUS server cannot be reached. RADIUS
•
generates this notification if it cannot receive any response to an accounting or authentication
request within the specified RADIUS request transmission attempts.
RADIUS server reachable notification—The RADIUS server can be reached. RADIUS generates this
•
notification for a previously blocked RADIUS server after the quiet timer expires.
• Excessive authentication failures notification—The number of authentication failures to the total
number of authentication attempts exceeds the specified threshold.
You can configure SNMP parameters to control the output of these SNMP notifications. For more
information, see Network Management and Monitoring Configuration Guide.
To enable SNMP notifications for RADIUS:
Step
1. Enter system view.
Command
security-policy-server { ipv4-address
| ipv6 ipv6-address }
Command
system-view
radius scheme
radius-scheme-name
attribute 15 check-mode { loose |
strict }
Command
system-view
31
Remarks
By default, no security policy server
is specified for a scheme.
You can specify a maximum of eight
security policy servers for a RADIUS
scheme.
Remarks
N/A
N/A
The default check method is strict.
Remarks
N/A