Honeywell XNX Technical Manual page 23

XNX Universal Transmitter
Figure 19. Passcode screen
Warning: The factory-set passcodes must be reset to prevent
unauthorized access to the transmitter's menus.
When the Passcode Screen is displayed, the first passcode
digit is highlighted� Use the switches to increment or
decrement through the values� Once the correct value is
displayed for the first digit,
the next digit or moves to the previous digit of the passcode�
✖
Figure 20. Entering the passcode
Repeat for each of the remaining digits in the passcode� If the
passcode is not entered correctly, the Invalid Passcode screen
is displayed and the user is returned to the General Status
screen�
Section 1 - Introduction
accepts the value and moves to
✓
1.4.4 Displaying Transmitter Information
While in the General Status display, swipe the magnet over the
magnetic switch to display information about the transmitter�
The General Status display will replace the bar graph in the
lower portion of the screen with the unit's serial number, the
date and time, and the unit's part number�
✓
21
Figure 21. Invalid Passcode screen
Figure 22. General Status Screen with Unit Information