1�4�1 Controls And Navigation - Honeywell XNX Technical Manual

XNX Universal Transmitter
Figure 10. Operation decal
The switch is actuated by the flux lines between the poles of the
magnet� This actuation method provides the most consistent
response�
A visual indication of the switch actuation will appear in the
lower right corner of the XNX display each time the switch is
activated�
In some menus where displayed values can be changed, the
magnet must be swiped over the switch to cause the numeral on
the display to advance through the available values� Use the
switch to return to a previous menu or field�
For the purposes of this manual, the instruction to use
, , or , means to activate the relevant magnetic switch as
✓ ✖
described above�
Section 1 - Introduction
Wand
Instruction
Decal
Alarm LED (red)
1.4.1 Controls and Navigation
Command
✓
Enter/Accept
✖
Escape/Back
Move Left/
✖
Decrement Value
Move Right/
Increment Value
18
Power LED (green)
Escape
Move Left
Decement Value
Figure 11. Front panel display of the XNX transmitter
Description
The Enter/Accept switch is used to access menus,
accept changes and to answer "yes" to system
prompts�
The Escape/Back switch is used to return to previous
menus or to answer "no" to system prompts�
The Left/Decrement arrow is used to move through
menu options or decrement values when entering text
or numbers�
The Right/Increment arrow is used to move through
menu options or increment values when entering text or
numbers�
Fault LED (yellow)
Enter/Accept
Switch Actuation
Visual Indicator
Move Right
Increment Value