Table of Contents
Advertisement
Modifying Logging to the Console Terminal and the Logging Buffer
SUMMARY STEPS
1. configure
2. logging history severity
3. logging history size number
4. commit
5. show logging history
DETAILED STEPS
Command or Action
Step 1
configure
Step 2
logging history severity
Example:
RP/0/RSP0/CPU0:router(config)# logging
history errors
Step 3
logging history size number
Example:
RP/0/RSP0/CPU0:router(config)# logging
history size 200
Step 4
commit
Step 5
show logging history
Example:
RP/0/RSP0/CPU0:router# show logging
history
Modifying Logging to the Console Terminal and the Logging Buffer
This task explains how to modify logging configuration for the console terminal and the logging buffer.
Logging is enabled by default.
Note
Cisco ASR 9000 Series Aggregation Services Router System Monitoring Configuration Guide, Release 4.2.x
298
Purpose
Changes the default severity level of syslog messages stored in the
history file and sent to the SNMP server.
• By default, syslog messages at or below the warnings severity
level are stored in the history file and sent to the SNMP server.
Changes the number of syslog messages that can be stored in the history
table.
• By default, one syslog message is stored in the history table.
When the history table is full (that is, when it contains the
Note
maximum number of messages specified with this command),
the oldest message is deleted from the table to allow the new
message to be stored.
(Optional) Displays information about the state of the syslog history
table.
Implementing Logging Services
Advertisement
Table of Contents
