Integra DTR-5.9 Service Manual page 107

DEBUG MODE-5
HDMI DEBUG MODE-1/2
HDMI-related operations can be checked to some extent by displaying HDMI debug mode.
To enter this mode
Hold down Display Display button for 3 seconds. Information display will last for about 8 seconds.
Content of Display
Segment No. --->
0 1
Video Input Format Status Description
Normal Source
Video Formats
Source Device Video Format : OK,
Sink Device EDID : OK
Normal State
Source Device Video Format : OK
Sink Device Hot plug : Low
Error State ---> Remedy
Source Device Video Format : OK
Sink Device HDCP Authentication : Fail
Error State ---> Remedy
Source Device Video Format : OK
Sink Device Resolution : Error
Error State ---> Remedy
Source Device Video Format : OK
Sink Device EDID Reading : Error
Error State ---> Remedy
Source Device Video Format : OK
Sink Device :
Busy(Cannot accept HDMI signal)
Error State ---> Remedy
FL Display
2 3 4 5 7
FL segment No. ---> 0
Description --->
Input Resolution
Display --->
(Example)
1
2
3
4
5
Description --->
Input Resolution
Progressive/ Interlace
i : HDMI, Interlace
p : HDMI, Progressive
I : DVI, Interlace
P : DVI, Progressive
Frame Rate
/6 : 60 frame/sec
/5 : 50 frame/sec
Video signal input
: Analog input
: HDMI input
6 8 9 10 11
1 2 3 4 5 6
i/p/I/P Frame Rate
i/p/I/P Frame Rate
i/p/I/P
DTR-5.9
12 13 14
7 8 9 10 11 12 13
Output Resolution i/p/I/P
Blinks
Error mark
Error mark
Error mark
Output Resolution i/p/I/P
14