Input Check Mode Table - Ricoh FW870 User Manual

SERVICE TOOLS

3.2.2 INPUT CHECK MODE TABLE

The on/off status of the selected electrical component is displayed on the
paper length indicator ("ON" or "OFF" is displayed.). If a program number not
used is selected, "NOT" is displayed.
Program
No.
-1 Original Set Sensor
-2 Original Lead Edge Sensor
-3 Original Registration Sensor
-4 Original Exit Sensor 1
-5 Original Switch Back Sensor
-6 Rear Original Set Sensor
-7 Paper Set Sensor
-8 Registration Sensor
-9 Fusing Exit Sensor
-10 Roll Lead edge Sensor
-11 Roll End Sensor 1
-12 Roll End Sensor 2
-13 Roll End Sensor 3
-14 Not Used
Main Motor Lock Signal
-15
Development Roller Lock Signal
-16
Wire Cleaner Motor Overcurrent
-17
Detection Signal
-18 Not Used
Exit Cover Open Switch
-19
-20 Upper Unit Open Sensor
-21 Original Feed Unit Open Sensor
-22 Paper Feed Unit Open Sensor
3rd Roll Feed Door Open Switch
-23
-24 Not Used
-25 Right Cutter Switch
-26 Left Cutter Switch
Not Used
-27
Original Mode Change Sensor
-28
-29 Not Used
Toner Overflow Sensor
-30
Total Counter Feed Back Signal
-31
Electrical Component
"ON" is displayed in a roll end condition.
"ON" is displayed in a roll end condition.
"ON" is displayed in a roll end condition.
"ON" is displayed when the main motor
rotates properly.
"ON" is displayed when the
development motor rotates properly.
"ON" is displayed when the wire cleaner
motor overcurrent is detected.
ON" is displayed when the exit cover is
open.
"ON" is displayed when the 3rd roll door
is opened.
"ON" is displayed in the long narrow
original feed mode.
"ON" is displayed when the sensor is
activated.
"ON" is displayed when the main PCB
receives the feed back signal from the
key counter or the total counter terminal
is open.
4-40
25 July 1996
Note