Power On Initial Setting Mode - Ricoh FW870 User Manual

25 July 1996
Program
No.
Motor Operation Number/Time
Display
58
Wire Cleaner Motor
59

3.3 POWER ON INITIAL SETTING MODE

The initial setting, when the main switch is tuned on, can be changed in this
mode. The procedure is as follows:
1. Turn on the main switch while holding the Emergency stop key down
and indicators blink).
2. Input the operation panel setting that the customer requires (paper size,
image density, etc.).
3. Turn off the main switch.
The setting, just before the main switch is turned off, is memorized as the
power on initial setting. It appears again when the main switch is turned on.
Electrical Component
Determines which is displayed when the
cutter motor (No. 45) or the wire cleaner
motor (No. 59) is activated.
ON: Total time of the motor operation
OFF: Total number of times the motor
operates.
Depending on the setting of No. 58, the
number of times the cutter mechanism
is engaged or the cutter motor on time,
is displayed.
4-43
SERVICE TOOLS
Note