Installing An Expansion Board - HP ProLiant ML110 G7 Maintenance And Service Manual

CAUTION:
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
Power down the server (on page 23).
1.
Remove the access panel
2.
Remove the air baffle
3.
Remove the full-length expansion board retainer, if any full-length expansion boards are installed
4.
("Removing the full-length expansion board
Push out to remove the slot cover.
5.

Installing an expansion board

Power down the server (on page 23).
1.
Remove the access panel
2.
Remove the air baffle
3.
Remove the full-length expansion board retainer, if any full-length expansion boards are installed
4.
("Removing the full-length expansion board
Remove the expansion slot cover
5.
For proper cooling, do not operate the server without the access panel, baffles,
("Removing the access
("Removing the air baffle" on page 26).
("Removing the access
("Removing the air baffle" on page 26).
("Removing an expansion slot
panel" on page 24).
retainer" on page 43).
panel" on page 24).
retainer" on page 43).
cover" on page 44).
Removal and replacement procedures 45