System Board - HP ProLiant ML110 G7 Maintenance And Service Manual

System board

To remove the component:
Power off the server
1.
Remove all power supplies.
2.
Unlock and remove the front bezel
3.
Remove the access panel
4.
Remove the air baffle
5.
Remove the battery pack
6.
Remove the expansion boards
7.
Remove all DIMMs.
8.
Disconnect all cables connected to the system board.
9.
Remove the heatsink.
10.
Open the processor retaining latch and the processor socket retaining bracket.
11.
Carefully lift the processor straight out of the socket.
12.
Place the processor on a static-dissipating work surface or inside an anti-static bag.
13.
Remove the system board screws.
14.
("Power down the server" on page 23).
("Removing the front
("Removing the access
("Removing the air baffle" on page 26).
("Removing the BBWC battery
("Installing an expansion
bezel" on page 25).
panel" on page 24).
pack" on page 47).
board" on page 45).
Removal and replacement procedures 64