Furuno VR-7000 Installation Manual page 75

Fabrication of the LAN cable
For VR-7010
Armor
L1
Cable jacket Cable jacket
Outer vinyl sheath
Vinyl tape (Width: 20)
1
Expose inner vinyl sheath.
4
approx. 9 mm
Fold back drain wire and
cut it, leaving 9 mm.
7
Using special crimping tool
MPT5-8 (PANDUIT CORP.),
crimp the modular plug.
Finally check the plug visually.
For other units
L2
Cable jacket Cable jacket
Inner vinyl sheath
2
25 mm
Remove the inner vinyl
sheath by approx 25 mm. Be
careful not to damage inner
shield and cores.
5
approx. 11 mm
Straighten and flatten the
core in order and cut them,
leaving 11 mm.
Modular plug
1 8
APPENDIX 2 CABLE FABRICATION
Armor
L1
Inner vinyl sheath
Outer vinyl sheath
Vinyl tape (Width: 20)
3
approx. 9 mm
Fold back the shield, wrap it
onto the inner vinyl sheath
and cut it, leaving 9 mm.
6
Drain wire
Insert the cable into the modular
plug so that the folded part of
the shield enters into the plug
housing. The drain wire should
be located on the tab side of
the jack.
L2
AP-5