Furuno VR-7000 Installation Manual page 48

2. WIRING
3. Fabricate the power cable referring to appendix 2.
4. Attach the rod terminal to the signal cores, then connect to the J1 port.
For details, see "ROD TERMINALS" on page AP-7 .
Fuse (FGMB 125V 2A PBF) Fuse (FGMB 125V 2A PBF)
Places at the bottom left of Places at the bottom left of
the J1 port. the J1 port.
5. Fix the power cable with the cable lock.
6. Reattach the chassis cover.
7. Connect the LAN and DVI cables.
8. Fix the power and LAN cable to the cable clamp with the cable tie (supplied).
9. Reattach the outside cover.
2-18
Cable lock Cable lock
For the power cable For the power cable
J1 port J1 port
Connect the power Connect the power
cable to this port. cable to this port.