Setting Up The Equipment; System Time Adjustment - Furuno VR-7000 Installation Manual

3.

SETTING UP THE EQUIPMENT

After installing the VR-7000, configure the system. For details, see the manual for
VDR Maintenance Viewer and Live Player V5.
The outline of the setup is as below.
Step 1. Network setting on PC and VDR
Step 2. Software setting
Step 3. Backup data setting
Step 4. Software configuration from file data
Step 5. Media management
Step 6. Other functions
After setting up, save a backup copy of the configuration data to both a CompactFlash
(CF) and the PC that has the VDR Maintenance Viewer.
3.1

System Time Adjustment

The system time, used for time-stamping VDR data, synchronizes with the UTC time
if the system time is behind the UTC time within 10 seconds. After Installing the VR-
7000, do the procedure bellow to set the system time within 10 seconds behind the
UTC time.
1. Remove seven binding screws to detach the cover from the DCU.
2. Connect a VGA monitor and keyboard to the DCU.
Connect a VGA monitor
to the VGA port.
3. Turn on the system while pressing and holding down the F2 key.
4. Wait until the BIOS display appears. (Keep the F2 key pressed.)
5. Set the system time within 10 seconds behind the UTC time.
6. Press the F10, Y, and Enter keys in order to save data.
7. Reboot the system.
8. Wait until the system time synchronizes with the GPS time.
Connect a keyboard
to the USB port.
3-1