Furuno VR-7000 Installation Manual page 40

2. WIRING
Cable fabrication
• DPYCY-1.5 cable
Cable jacket Cable jacket
Fasten this part with the cable gland.
• FR-FTPC-CY cable
Cable jacket Cable jacket
Fasten this part with the cable gland.
Notes for wiring
• Insert the rod terminals to the terminal board securely and fasten the terminal
board screws to keep the wires from touching the terminal board cover.
• When it is hard to attach the rod terminal to the cores of the DPYCY-1.5 cable,
cut out the wire jacket. Be careful not to damage the cores when cutting the wire
jacket
Wire jacket
Cut the wire jacket.
• When it is hard to insert the rod terminals attached to the FR-FTPC-CY cable
to the terminal board, cut the rod terminal about 2 mm.
2-10
35 20
Twist the wires.
Vinyl sheath
Vinyl tape (width: 10)
35 20
Cut the unused wires.
Vinyl sheath
Vinyl tape (width: 10)
Core
100
Attach the rod terminal.
100
Attach the rod terminal.
Attach the rod terminal to the core.
Rod terminal