Junction Box If-8530 (Option) - Furuno VR-7000 Installation Manual

2.11

Junction Box IF-8530 (Option)

Note: To connect the IF-8530 to the VR-7010, update the program of the IF-8530 us-
ing the IF-8530 version-up kit (OP24-48, option).
2.11.1 Location of connectors
Connect the serial, analog and digital signals to the terminal boards or connectors in
the junction box. Use the 2.5 mm
For serial and analog signal input, the DIP switch setting is required (see
section 2.11.2).
DCU
CH1 CH3
Degital
Channels
Serial
Ground terminal
(IV-8sq.)
Location of connectors and cable clamp
Serial channels
CH4 CH5 CH6 CH7 CH8
Serial Serial Analog Power supply
LAN
Spare Digital
Digital
2
or AWG14 wires to connect the signals.
CH1 CH2
Analog
channels
DC 24V IN
Analog
2. WIRING
DIP switch (from left):
S5 (Keep the default)
S4 (Baud rate 1)
S3 (Baud rate 2)
S2 (Analog 1)
S1 (Analog 1)
2-35