Fluke 5080A/SC User Manual page 27

Command
SCOPE(?)
TRIG(?)
OUT_IMP(?)
SCOPE(?) <value >
Description Programs the 5080A to use the Megohm Option, if installed.
Parameters <value> = OFF
Example SCOPE VOLT; OUT -2 V, 0 Hz
SCOPE VOLT; OUT 4 V, 1 kHz
SCOPE EDGE; OUT 0.5 V, 5 kHz
SCOPE LEVSINE; OUT 1 V, 200 kHz (Leveled sinewave, 1 V p-p,
SCOPE MARKER; OUT 2 MS
Query
SCOPE?
TRIG(?) <value >
Description Programs the scope options trigger out BNC.
Parameters <value> = OFF
Example
TRIG OFF
Query
TRIG?
riešenia na presné meranie
Table 2. Overlapped and Coupled Commands
Overlapped
Yes
Yes
Yes
Turns the Scopt option off. Programs 0 V, 0 Hz
output at the NORMAL terminals.
VOLT Oscilloscope ac and dc voltage mode. Programs
20 mV p-p, 1 kHz, output at the SCOPE BNC,
output impedance 1 MΩ standby if from OFF or
previously in standby.
EDGE Oscilloscope edge mode. Programs 25 mV p-p,
1 MHz, output at the SCOPE BNC, standby if
from OFF or previously in standby.
LEVSINE Oscilloscope-leveled sine mode. Programs
30 mV p-p, 50 kHz, output at the SCOPE BNC,
standby if from OFF or previously in standby.
MARKER Oscilloscope Marker mode. Programs the period
to 1 ms, output at the SCOPE BNC, standby if
from OFF or previously in standby.
Returns the current mode of operation (OFF,
VOLT, EDGE, LEVSINE, or MARKER).
Turns the trigger output off.
DIV1 Turns the trigger output on. Frequency is the
same as the signal at SCOPE output.
DIV10 Turns the trigger output on. Frequency is 1/10
the signal at SCOPE output.
DIV100 Turns the trigger output on. Frequency is 1/100
the signal at SCOPE output.
Turns the trigger output off.
Returns the mode of the Megohm option (OFF,
DIV1, DIV10, or DIV100).
http://www.elso.sk
Scope Calibration Option
Summary of Commands and Queries
Coupled
Yes
No
Yes
(dc voltage, -2 V)
(ac voltage, 4 V p-p, 1 kHz)
(Edge, 0.5 V p-p, 5 kHz)
200 kHz)
(Marker period of 2 ms)
19