Device - Invacare TDX SP2 User Manual

1. Secure the mobility device with the tie-down system
belts at the following locations:
a. All Wheelchairs — four tie down points A on the
wheelchair base (two at the front and two at the
rear).
b. Systems with Lifter and Ultra Low Maxx Seating —
two additional tie down points B on either side of
the seat at the front of the seat rails.
2. Secure the mobility device by tensioning the belts in
accordance with the tie-down system manufacturer's
user manual.
8.3.2 How the user is secured within the mobility device
CAUTION!
Risk of injury if the user is not properly secured
within the mobility device
– Even if the mobility device is fitted with a
posture belt, this is no substitute for a proper
safety belt which complies with ISO 10542 in
the transport vehicle. Always use the safety
belt installed in the transport vehicle.
– Safety belts must be in contact with the user's
body. They must not be held at a distance from
the user's body using parts of the mobility
device such as armrests or wheels.
– Safety belts must be pulled as tightly as
possible without causing the user discomfort.
– Safety belts must not be positioned while
twisted.
– Ensure that the third seat belt anchorage point
is not fixed directly to the vehicle floor, but to
one of the vehicle uprights.
1578997-E
CAUTION!
Risk of injury during use of the mobility device
as a vehicle seat if a headrest is wrongly
adjusted or not installed
This can cause the neck to be hyperextended
during collisions.
– A headrest must be installed. The headrest
optionally supplied for this mobility device by
Invacare is perfectly suitable for use during
transport.
– The headrest must be adjusted to the user's
ear height.
Seat belts may not be held at a distance from the user's
body using parts of the mobility device such as armrests
or wheels.
Transport
97